;ADF file for the NE/2-32 lan adapter ;written by Carleton E. Watkins 17-MAR-89 AdapterID 07151h AdapterName "NE/2-32" NumBytes 1 nameditem Prompt "I/O, RAM (in HEX)" Choice "3000-302F, 000C0000-000C7FFF" pos[0]=XXXX001Xb io 3000H-302FH mem 000C0000H-000C7FFFH Choice "4000-402F, 000D0000-000D7FFF" pos[0]=XXXX010Xb io 4000H-402FH mem 000D0000H-000D7FFFH Choice "5000-502F, FFF90000-FFF97FFF" pos[0]=XXXX011Xb io 5000H-502FH mem 0FFF90000H-0FFF97FFFH Choice "6000-602F, FFFA0000-FFFA7FFF" pos[0]=XXXX100Xb io 6000H-602FH mem 0FFFA0000H-0FFFA7FFFH Choice "7000-702F, FFFB0000-FFFB7FFF" pos[0]=XXXX101Xb io 7000H-702FH mem 0FFFB0000H-0FFFB7FFFH Choice "9000-902F, FFFC0000-FFFC7FFF" pos[0]=XXXX110Xb io 9000H-902FH mem 0FFFC0000H-0FFFC7FFFH Choice "D000-D02F, FFFD0000-FFFD7FFF" pos[0]=XXXX111Xb io 0D000H-0D02FH mem 0FFFD0000H-0FFFD7FFFH Help "The I/O address ranges shown are the addresses at which the adapter will decode for control and use of the network controller, reset function, and Ethernet ID address PROM. The RAM address will determine where the adapter's packet buffer RAM will appear in host system's memory map." nameditem Prompt "Interrupt Request Level" Choice "IRQ 3" pos[0]=X000XXXXb int 3 Choice "IRQ 4" pos[0]=X001XXXXb int 4 Choice "IRQ 5" pos[0]=X010XXXXb int 5 Choice "IRQ 9" pos[0]=X011XXXXb int 9 Choice "IRQ 10" pos[0]=X100XXXXb int 10 Choice "IRQ 11" pos[0]=X101XXXXb int 11 Help "The IRQ selection assigns which interrupt request line the lan adapter will use to signal the microprocessor via the interrupt controller." nameditem Prompt "Connector Selection" Choice "Thin Wire" pos[0]=1XXXXXXXb Choice "Thick Wire" pos[0]=0XXXXXXXb Help "This selection allows the user to choose either the thick or thin connector available on the board."